Genzler Genzler re/Q Dual Function EQ Pedal

$ 212.40excl. VAT

In stock

Genzler re/Q Dual Function EQ Pedal

Is a low noise, ALL ANALOG multi-function HIGH PASS FILTER – LOW PASS FILTER and 5 BAND EQ pedal that gives the player complete tonal control over the cut-off of the extreme low and high frequencies, plus 5 bands of peak-dip equalization.  The filter section is foot switched independently from the EQ section, and there is additional make-up gain or cut after the EQ for balancing of levels or to act as an additional boost/cut function when the EQ is switched into the signal path.

The Re/Q — DUAL FUNCTION EQUALIZATION pedal, offers 2 specific and separate filter networks, HPF and LPF filters with on/off switching and a 5 band EQ network, with its own on/off switching. And the EQ network provides an EQ Output level of +/- 9dB.  This versatile design allows the pedal to be used as a clean boost, and is a great combination with the 4 ON THE FLOOR, CLASSIC BASS OVERDRIVE pedal.

Specs

Knobs

Low
This control +-12dB @ 90Hz
Low Mid
This control can either +-12dB @ 250Hz
Mid
This control can either +-12dB @ 630Hz
High Mid
This control can either +-12dB @ 1.3kHz
High
This control can either +-12dB @ 2.6kHz
High Pass (Low Cut) Filter
This control is a variable frequency low cutoff of the signal into the pedal. Increasing the frequency of this roll-off, reduces the low frequency energy and helps retain the articulation and note definition with higher settings.
Low Pass (High Cut) Filter
This control is a variable frequency high cutoff of the signal out of the pedal. Reducing the frequency of this roll-off reduces the high frequency energy in the signal and can mellow out the tone of the signal.
EQ Output Level
This controls the level of overall EQ added to the signal @ +/-9dB

Switches

Filters Footswitch
Pressing the footswitch alternates the pedal’s operation between BYPASS mode (RED LED) and ACTIVE mode (BLUE LED). No controls on the pedal will function in bypass mode.
EQ Footswitch
Pressing the footswitch alternates the pedal’s operation between BYPASS mode (RED LED) and ACTIVE mode (BLUE LED). No controls on the pedal will function in bypass mode.

Power

Power
9VDC-18VDC (low noise type), either polarity (auto-detecting), 40mA max (Power supply not included)

Outputs

Input
1/4" Pedal input, nominally instrument level but can accept line level with the sensitivity switch set low. Input impedance is 1M
Power Jack
This pedal contains circuitry that auto-detects both the voltage and polarity of the attached power supply. The pedal will function properly from 9V to 18V, center positive or center negative polarity
Output
1/4" Pedal output, nominally instrument level but can output up to line level with the DRIVE and CLEAN volumes turned up.

Dimensions

Dimension
12,7cm x 10,4cm x 5,9cm
Weight
0,6 kg
You are offline
Reload page when online